This is a really good tip Robert. Thanks for that!
Thinking about it, if I were to run into this, I might try fitting a
spacer inside the angle drive at the gearbox attachment side to take up
the needed distance. Something similar to a garden hose washer trimmed
to fit inside the screw cap on the angle drive.
Again, I haven't done it, it's just a thought.
Jm Franks
Robert Liam Gannon wrote:
> The 3/8's should be measured at the speedometer end. Insert the inner cable
> into the sheath until it will not go any further. At that point, you try
> turning the inner cable by hand to make sure it is in the angle drive. Once
> you are satisfied that it is where it should be, go to the end that inserts
> into the Speedo and measure. It should be no more than 3/8's. Guess I wasn't
> clear on that point. Sorry.
>
> Robert L. Gannon
> http://home.comcast.net/~trsix74/wsb/index.html
|