On Thu, 11 May 2006, Saul W. Adelman wrote:
> I am rebuilding the motor with a mechanic and we got to the point of
> installing the damper. But the problem is that we can't find it. We are
> going to search again high and low. So, in anticipation of not finding the
> damper that came off the TR6 before it went to the machine shop, I am
> seeking advice about who should I have rebuild one if (and when) I can find
> a used one. And I guess I need the one with the 1-2 inch pulley which
> apparently are very hard to find.
>
>
>
> So if you have a recommendation for rebuilding a damper I would appreciate
> it.
Don't forget that you can buy these new. I got one from Moss (or was it
APT???) about three years ago. Not free (over $175), but NEW.
This is a part that you should not skimp on.
BTW, I've got several used ones that need new rubber if you get desperate.
rml
------------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent
Consultant MIT unix-linux-help |
Voice:617-253-7438 FAX: 617-258-9535 | Cell: xxx-xxx-xxxx
------------------------------------------------------------------------------
|