Transfer the oil pressure switch from the block to the end of the T-fitting
supplied with your feed kit, fit the T to the block ensuring the open port
faces to the rear. Fit the non-banjo end of the line to the T-fitting and
replace the wire on the oil pressure switch. [You may want to insert a small
roll pin in the end of the line first, but this is not mandatory.] Remove the
hex bolt from the top rear (left side) of the head and fit the banjo fitting.
Make sure you use the copper crush washer.
BTW--I assume the Goodparts rollers are bushed to the rocker shaft (i.e., no
needle bearings). If this is not the case, you should not fit the external
feed as you will cause a significant drop in oil pressure.
Good luck.
Rick O.
72 TR6
|