Bob,
Snipped a good bit of the original post.
On the conversion to the lip seals, got any recommendations on manufacturer
and/or PNs??
I just re-did mine with new felts (and bearings) and found the bearing
adjustment creative at best
Thanks
Steve
Jon's message implied that there is a quality control problem with many of
the stock felt-seal (orignal type) grease seals (the felt is too thick).
This makes sense because if you see the pedal to the floor thing a lot,
you will notice that the bearings seem very loose when you go to check
them. Of course one fix for the seal problem is to convert to modern
lip-type seals - set 'em and forget 'em. But you still have to check the
bearings!!!
rml
----------------------------------------------------------------------------
--
Bob Lang Room N42-140Q | This space for rent
Consultant MIT unix-vms-help |
Voice:617-253-7438 FAX: 617-258-9535 |
----------------------------------------------------------------------------
--
/// 6pack@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|