RE: TR250 brake MC disassembly

["Creamer, Mark" <CreamerM@cintas.com>]

I struck out at Sears and everywhere else I looked for the 1/2" allen, so I 
tried a short high-grade
bolt, with two nuts on the other end. Put the bolt head in where the allen 
wrench would go, the MC in
a vise, and turned the counter-tightening nut with a long wrench. 
Unfortunately, it was too far gone.
No way it was going to move. I ended up putting in a whole new MC, but I'm 
actually glad it turned out
that way. The new MC looks and works great

<mc>