Hi List,
There are solution out there using either the Z axles or the Corvair
axles. Both are nice and strong and for those that do track events, the
assembly/teardown is dead-nuts simple and setting end-float and bearing
preload is done with shims (not crush collars).
I highly recommend looking into this option if you drive your TR6 hard.
I run Corvair axles that I got from list member Dave Wingett. I am very
satisfied with the results.
rml
------------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent
Consultant MIT unix-vms-help |
Voice:617-253-7438 FAX: 617-258-9535 |
------------------------------------------------------------------------------
|