Bob,
What would be the easiest way to determine which set you have?? If I
have the covers removed, can I just count the teeth on the ring gear??
Are all of the pinion gears the same??
Thanks,
Jay
======================
On Wed, 29 Jan 2003 10:49:32 -0500 (EST) "Robert M. Lang"
<lang@isis.mit.edu> writes:
> On Wed, 29 Jan 2003, Alan & Debbie Lindner wrote:
>
> [stuff deleted]
>
> > How many different rear end ratios are there?
>
> From the factory there was 3.70 (US Fed. Spec) and 3.45 (PI cars).
>
> There were various ratios available from the competition dept.,
> 4.10
> (available as an optional ratio on the TR4's from the dealer) and
> then
> 4.33, 4.55 and 4.88 (actually 4.875).
>
> > I thought they were
> > 3.7:1 or 3.45 (except for Bob Lang with the 4.1:1).
>
> Just for the record, I run 3.70 on my street car and currently run
> 4.88 in
> the race car. The race car is going to get the 4.33 set over the
> winter.
> And I'd better get "crackin'", there's about nine weeks to the first
> event
> in 2003. YIKES!
>
> I have thought about 4.10's for the street car (and an O/D) but the
> race
> car uses up most of my Triumph $$$. The race car also uses up some
> of my
> mortgage money and some of my food money. If I still drank beer, it
> would
> use some of that too. =:-0
>
> > Alan
>
> regards,
> rml
>
-------------------------------------------------------------------------
-----
> Bob Lang Room N42-140Q | This space for
> rent
> Consultant MIT unix-vms-help |
> Voice:617-253-7438 FAX: 617-258-9535 |
>
-------------------------------------------------------------------------
-----
|