Hi,
I am trying to rebuild my PDWA. I have an early TR6, so I have the brass
unit. I ordered a rebuild kit from Rimmer Brothers, since they were the only
company I could find that actually listed it. Instead of the cone shaped
rubber seals that I need, the kit included two each of two different size
o-rings. Does anybody know what I am supposed to do with these? I can't
figure out how they might replace the cone shaped pieces I have and seal the
cylinder in the PDWA. Does anyone have experience with this, or know where I
can get the cone shaped seals? I have sent an e-mail to Rimmer Brothers, but
have gotten no response.
Thanks,
Tom
'69 TR6
|