Thanks Jim,
By "eyebrow" do you mean the "U" cork seal?
No seal--then, the U-shaped cork seals that fit in the groves at front
and rear of the pan mate up against bare metal surfaces either end of the
crank caps, and do not mate against another cork seal of similar contour?
There is no other cork seal at the crank ends other than those U seals
installed in the pan?
While I`m here, what is the opinion on the rubber rear seal vs the
cork? I`ve got both.
Bert
----- Original Message -----
From: "Jim Johnson" <bmwwxman@gmail.com>
Cc: <spridgets@autox.team.net>
Sent: Tuesday, March 29, 2011 4:02 PM
Subject: Re: [Spridgets] Bearing Replacement Follow Up
> Buy replacement pan gaskets. All of them. Install with RPV. There is no
> seal
> on the rear main. Be sure to get the "eyebrow" for the rear main bearing
> cap
> tight against the crank.
>
> Cheers!!
> Jim
>
> On Tue, Mar 29, 2011 at 3:15 PM, Bert Shirey
> <bertshirey@zoominternet.net>wrote:
>
>> Guys and Gals,
>>
>> I dropped the pan on the Midget today to inspect those rod bearings.
>> There
>> was a small amount of that shiny non-magnetic debris in the bottom. Small
>> amount might be like a small bullet, but so far I was relieved there were
>> no
>> nuts and bolts or big chunks of stuff that would ruin my day.
>>
>> Here`s another question maybe someone can answer:
>>
>> At the front and rear where the "U" sump seals meet the crank ends, I
>> can
>> see more cork seal that apparently mated the contour of those on the
>> sump.I
>> believe these may be part of the U sump seals that remained behind, tore
>> away
>> clean from the lower part. The pan has never been removed and was pretty
>> tight.
>>
>> I do see the parts manual shows only one seal (main bearing cap seal)
>> at
>> the front and rear that fit into the groves in the pan to mate with the
>> crank.
>> But before I try to get those other cork pieces out, I`d better ask.
>> Cheers,
>>
>> Bert Shirey
>> _______________________________________________
>>
>> Donate: http://www.team.net/donate.html
>> Suggested annual donation $12.75
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe/Manage:
>> http://autox.team.net/mailman/options/spridgets/bmwwxman@gmail.com
>>
>>
>
>
> --
> Cheers!!
> Jim Johnson
> Don't miss the BIG PARTY!! Midget 50th Anniversary!
> Elkhart Lake, WI July 18-22, 2011
> Info & Registration here:
> http://www.sprite-midgetclub.org
> _______________________________________________
>
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/spridgets/bertshirey@zoominternet.net
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|