[Spridgets] KIng Pin Reamer

[cbking at alum.rpi.edu (Chris King)]

If you plan to send them out, send them to Peter C. He did mine back
when I rebuilt my front end. Great job, great service.

-=Chris

Chris King
http://home.comcast.net/~kvcbk/

<-----Original Message-----> 
>From: James Gruber [thistle_3619 at yahoo.com]
>Sent: 1/15/2011 3:29:25 PM
>To: spridgets at autox.team.net
>Subject: Re: [Spridgets] KIng Pin Reamer
>
>Anyone have a King Pin Reamer available? A little pricey to purchase.
Getting
>around to reinstalling and reassembling new Major Suspension Kit. Lower
>Bushings fit fine on fulcrum pin but brass upper bushings are a no go
and
>evidently need reaming. IS this a send off to Apple Hydraulics and ask
them to
>fit for $60 a side or reuse the old bushings as is.
> 
>Wishbones and fulcrum pins are redone now. Thoughts from the list on
getting
>upper bushings to fit. And is a press necessary to get them to fit in
place?
>Shop manual gives zero details on fitting these bushings.
>_______________________________________________
>
>Donate: http://www.team.net/donate.html
>Suggested annual donation $12.75
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>Unsubscribe/Manage:
>http://autox.team.net/mailman/options/spridgets/cbking at alum.rpi.edu
>
>.