Are we still talking about the BRASS radiator? Not going to go well
welding to brass..
Lester
.. although the way my email has been working this could be talking
about someone's forehead..
On Apr 13, 2009, at 2:10 PM, Kirk Hargreaves wrote:
> That pop out tool is mainly for the thinner sheet metal of a car
> body - for
> use with shallow dents.
>
> I used to have one. . gave it away to someone. It was not that
> good even
> for shallow dents on thin metal.
>
> The cleanest way to pull that dent out would be to use one of those
> weld pin
> devices that will weld in a pin to the area. You then attach a dent
> puller
> to the pin to pull the dent. After that, you grind the area to
> remove the
> pin weld. This way, you are not messing with the radiator such as
> with a
> regular dent puller where you have to use a screw to go into the
> material.
>
> You would still need to finish the area with plastic body filler,
> sand and
> paint. Not sure if body filler can handle the temps of the radiator
> top. .
> but I think it should be ok.
>
> Kirk
> 59 BE
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|