NOT RIGHT!!!!
The thrust surfaces should be facing each other. Said another way, on each
individual wheel, the thrust sides should be towards the center of the hub.
Paul A
----- Original Message -----
From: "Mark Endicott" <mark@nashvilletn.org>
To: "spridgets list" <spridgets@autox.team.net>
Sent: Wednesday, May 24, 2006 8:44 AM
Subject: Front Wheel Bearings Thrust Face
> I am reassembling the front hubs on my Bugeye and need a confidence check
on
> the bearing placement. As I recall from doing it 10 years ago the
"Thrust"
> marking on the bearings are like this:
>
> The "Thrust" marking faces the center of the car on both bearings. Outer
> bearing "Thrust" side mates with the spacer and the inner bearing "Thrust"
> side mates with the grease seal. My bearings are marked so I don't have
to
> try to figure that out.
>
> Please correct me if this isn't right.
>
> Mark
> Nashville
|