When I had a similar problem with my 72 and Riverside setup, I had to
adjust the pushrod to have a little free play because it would overdrive
the clutch. The effect felt the same as if the clutch had not released.
chuck
David Riker wrote:
>I'm about out of ideas. I have a 1275 with a Datsun 5 speed. New flywheel,
>new clutch, new pressure plate, new MG 1098 slave cylinder, new 1275/1500
>master cylinder, new nylon clutch hose, no play in clevis pin at top.
>Adjusted length of pushrod to release arm so throw out bearing contacts
>pressure plate fingers but is not applying pressure.
>
>Clutch does not completely disingage. Same problem before all above items
>were replaced. No air in system, new fluid, no slop or play in any part of
>system.. Is it possible the release arm is bending???
|