In a message dated 4/30/03 5:26:57 PM Eastern Daylight Time,
tspeed@carolina.rr.com writes:
> His variation is to coat the bottom of the
> gasket and the mating surface of the head with liberal amounts of motor
> oil. Then install the cover to the head loosely. After it sets up
> overnight, you have a perfect seal and don't have to re-apply anything
> since there is usually a little bit of oil around to keep the cork nice
> and pliable.
>
- - - - - - - - - - -
Where does the silicone go?
Allen Hefner
Phila. Region SCCA Rally Steward
'77 MG Midget (#51 FSP)
'75 MG Midget (The Project)
'99 Ford Contour SE Sport (24v V6)
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|