At 09:08 AM 5/1/2003, Ajhsys@aol.com wrote:
>In a message dated 4/30/03 5:26:57 PM Eastern Daylight Time,
>tspeed@carolina.rr.com writes:
> > His variation is to coat the bottom of the
> > gasket and the mating surface of the head with liberal amounts of motor
> > oil. Then install the cover to the head loosely. After it sets up
> > overnight, you have a perfect seal and don't have to re-apply anything
> > since there is usually a little bit of oil around to keep the cork nice
> > and pliable.
>- - - - - - - - - - -
>Where does the silicone go?
>Allen Hefner
====
Usually lodges someplace in the engine, which is why Tom's suggestion is
better.
Peter C (see you at the Spree03)
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|