Best way to disassemble a joint.
Find a pair of tweezers, a rubberband, and a book of matches. While holding
the joint with the rubberband wrapped tweezers, light with .....
Opps wrong kind of joint. Nevermind.
Anon
On 11/15/01 2:39 PM, "chuck" <chuckc@attglobal.net> wrote:
> Hey Guyz,
>
> While filling the front shocks I nothiced that the boots
> over the ball joints on the tie rod ends are looking like
> they really wanna be replaced. Before I destroy the
> front end, what are the acceptable practices for
> disassembling that joint? Seems like if I loosen the
> nyloc nut on the ball joint, and tap the end of the
> ball joint bolt down, it should release enough to
> let me replace the boot. But .... it won't budge.
> Besides "use a bigger hammer" technology, what
> advice can you offer.
>
> thanks,
>
> chuckC
|