But .. do I want to let the ball out? Maybe I'm goin' about this
all wrong. I think I want the tapered (?) bolt to slide out of the
steering arm (that is attached to the back of the axle stub
mount)? I have just now tried heat and 2 hammers (BIG 'UNS)
and no luck so far. Gonna take a little cocktail break. See
if that doesn't nelp.
chuckC
Geoff Branch wrote:
> Orrrrrr.....put a good
> sized hammer on the far side of the outer part of the joint and hold it tight
> against. Then smack the opposite side with another big hammer, HARD. This
> often distorts the joint enough to let the ball out. Good luck.
|