Jon,
Probably hard to come up with just one if someone has a complete set. I
have a couple more blocks than I have rods for. I'd make sure they can be
reversed. They look pretty much the same, but I think I'd want to be
positive on that issue.
Gerard
At 6:28 PM -0700 7/12/01, Jon Paschke wrote:
>Thanks Gerard, I know about the offsets but it looks like they are all the
>same just reversed on two pistons. I haven't had any offers for any rods yet
>though.
>Jon
>
>> >
>> You should note that the rods have offsets. If you have the rod numbers
>all
>> on the same side, as you should (I'm not sure if you can flip them), you
>> need to make sure they are in the right position. If you are not getting a
>> number four rod, 2 and 4 and 1 and 3 are offset the same way.
>>
>> Gerard
>>
>> At 11:51 AM -0700 7/12/01, Jon Paschke wrote:
>> >Hi All,
>> >
>> >I'm needing a rod for my 1275 Spridget motor. I have 3 of the AEG-625
>Midget
>> >rods but can't find a 4th. This number is cast into the rods so I want to
>> >match it with another, also if I get a choice it is number 4 but I can
>> >restamp. Thanks in advance, I expect to pay but hopefully not through the
>> >nose. ;-)
--
Please visit Four Points Travel -
Discount Online International Travel Reservations
http://www.gerardsgarage.com/fourpoints
To make a reservation please call Toll Free 1-800-272-3253
G G Gerard Chateauvieux
E A
R R pixelsmith@gerardsgarage.com
A A
R G Pixelsmith on Duty
D E
S http://www.gerardsgarage.com
|