Just for the record, I only tried "randomly" adjusting the distributor to
see if it would make any difference. :-) I mostly wanted a confirmation of
my sneaking suspicion that there were worse problems afoot...meaning timing
chain problems. Flames shooting out the carb certainly aren't natural. heh
heh
Thanks,
adrian
-----Original Message-----
From Ajhsys at aol.com [mailto:Ajhsys@aol.com]
Sent: Tuesday, April 11, 2000 11:38 AM
To: adrian@workgroup.net; spridgets@autox.team.net
Subject: Re: Won't Start...
In a message dated 4/10/00 6:12:31 PM Eastern Daylight Time,
adrian@workgroup.net writes:
<< Part of my earlier problem with getting the car started was another bad
starter. Got that replaced and now it is turning over fine. New plugs,
new
cap, new wires, new rotor button, it's getting fuel, it's getting spark.
I'm turning the distributer to try to get it in time. I've tried rotating
180 degrees. The car turns over and fires, but won't start, and shoots
flames out the carb sometimes. Anybody have any ideas what could be the
problem? It's a 1500 newly rebuilt with the higher compression pistons, by
the way. Thanks! >>
- - - - - - - - - - - - - - - - - -
It sure sounds like ignition timing. If the timing is firing the plug
whilst
an intake valve is open, you will get flamed out the distributor. (Oooo,
that sounds bad.)
It also sounds like you are randomly turning the dizzy to try to get
something to work. That rarely works! Think it through. You need to set
the #1 cylinder (that's the front one) at top dead center on the compression
stroke. Then you need to put the dizzy in so the rotor is pointing at the
#1
plug wire.
Mark the crank pully, or check the location of the timing marks on it, so
that it is accurately indicating TDC, then rotate the engine to the correct
number of degrees mark BEFORE TDC. Turn the dizzy to set the rotor at #1.
It should be static-timed at this point. Then see if it starts and set the
timing with a light.
Check the archives on how to find TDC on cyl. #1.
Another possible problem is valve timing. Are you sure the timing chain
isn't off a tooth or two?
I hope this helps, and would someone please check that I am correct in my
suggestion? I don't have any books here at work. (Maybe I'll put up a
workshop shelf in the office.)
Allen Hefner
SCCA Philly Region Rally Steward
'77 Midget
'92 Mitsubishi Expo LRV Sport
|