Bryan:
Before I switched to the Nissan tranny, I tried the roller throwout bearing.
It works great and required no modifications anywhere. When below about 50
degrees outside, it would chatter a little bit after it was a year old, but
upon removal a year after that, everything looked just fine. Once you
replace the throwout bearing the next weak link is the clutch plate, as the
fingers and springs break easily.
YMMV
David Riker
74 Midget
63 Falcon
>>>
> 2) has any one installed one of the 1275-clutch roller bearings?? I have
one that I got
> from Winner's circle installed, and I was wondering if I was supposed to
modify the
> standard spring pressure plate when using this roller bearing?
>
> Regards,
> Bryan Vandiver (59- bugeye)
> San Jose, CA
>
|