Hi Bruce,
I was told by my Mechanic friend to use a tap. Find a tap of suitable size
that is slightly larger then the hole. Push a small washer into the hole
bottom to keep from scratching the hole. Thread the tap into the brass
bushing when it bottoms out, keep turning and it walks right up the tap.
Worked like a charm on my MGB.
I've used the punch and grease also but the clearence have to be so tight for
it to work it was a real hassel. This way was so much easier because everyone
has a taps laying around the shop.
Rick
Bruce Woodward wrote:
> I'm getting ready to pull motor on my 1098cc Mark II Midget and renew the
> first motion shaft bushing, the little bronze bushing that is inset in the
> crankshaft and centers the input shaft of the transmission.
>
> My question: None of the local supply houses have an expanding bushing
> puller small enough (1/2" inside diameter) for purchase. Anybody got any
> secrets to alternative removal of this bushing?
>
> bruce@woodward-realty.com
--
52 MGTD,Sparky 74 MGB, B-tris 76 XJ12 Coupe, Jacque
60 Bugeye, Puddles 58 MGA Coupe, Ruby
http://www.softcom.net/users/walters
http://www.geocities.com/Heartland/Acres/4644
|