Yes.... Pack it in wheel bearing Grease....and then put the Clutch
alignment tool in and tap on it with a hammer.. the grease will hydraulic
it out.... Trust me it works for me... hmmm
Keith Turk
Austin Healey 100 / Bugeye / Box Sprite / Bonneville Land Speed Racer
Camaro ( D Gas Altered )
----------
> From: Bruce Woodward <brucewoodward@kconline.com>
> To: Spridgets <spridgets@autox.team.net>
> Subject: first motion shaft bushing
> Date: Thursday, May 13, 1999 6:59 PM
>
> I'm getting ready to pull motor on my 1098cc Mark II Midget and renew the
> first motion shaft bushing, the little bronze bushing that is inset in
the
> crankshaft and centers the input shaft of the transmission.
>
> My question: None of the local supply houses have an expanding bushing
> puller small enough (1/2" inside diameter) for purchase. Anybody got any
> secrets to alternative removal of this bushing?
>
>
> bruce@woodward-realty.com
>
>
|