To: | <mike@duvallvideo.com>, "Barney Gaylord" <barneymg@mgaguru.com> |
---|---|
Subject: | Re: [Mgs] loctite question |
From: | "PaulHunt73" <paulhunt73@virginmedia.com> |
Date: | Mon, 7 Jan 2013 16:48:16 -0000 |
Cc: | mgs@autox.team.net |
Delivered-to: | mharc@autox.team.net |
Delivered-to: | mgs@autox.team.net |
References: | <20130106.143701.15815.3@webmail-beta01.vgs.untd.com> <ED1C2572A0DA4449A7D0DFCB0E1DFADF@paul> <201301071551.r07FpN2s002495@nlpi176.prodigy.net> |
Fairy nuff. It does depend just how much thickness is going to be needed to bring the holes into line, it could need a washer. ----- Original Message ----- > In that application the nut is not bearing directly on the shims. A nut > bearing directly on a thin shim will destroy the shim as the nut is > tightened. If you are going to shim a nut for rotation reference, you > need a hard flat washer between nut and shim, and the washer should be > keyed so it doesn't rotate. _______________________________________________ Mgs@autox.team.net Archive: http://www.team.net/archive Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | [Mgs] loctite question, Don |
---|---|
Next by Date: | Re: [Mgs] loctite question, PaulHunt73 |
Previous by Thread: | [Mgs] loctite question, Don |
Next by Thread: | Re: [Mgs] loctite question, PaulHunt73 |
Indexes: | [Date] [Thread] [Top] [All Lists] |