Larry,
Sorry for the late response, out driving the V8 last
night and most of today :-)
I used a pretty rough looking combination of hose and
pipe. I'm using the Ford 289 radiator, which has a 1
3/4" outlet on the right side. From the outlet, I
have a hose 90, a very short length of pipe, and then
a hose 45, a length of pipe, up by the frame rail, and
then another hose 90 to the water pump. Does it work?
Sure. Is it pretty? No. For pipe, I used PVC
coated conduit, 1.5" electrical conduit. Pretty
expensive stuff, used in industrial settings. But
it's a little quieter than regular pipe.
Hope this helps, and good luck with the project.
Glenn
--- Larry Hoy <larryhoy@prodigy.net> wrote:
> OK Glenn, how'd you do it?
>
> I checked the archives, saw that you had the
> question out there, but didn't see
> an answer.
>
> Seems like there are too many things to route around
> to get anything to work.
>
> Any suggestions.
>
> Hopefully this car will run by Monday.
>
> Larry Hoy
>
__________________________________________________
Yahoo! Mail – Free email you can access from anywhere!
http://mail.yahoo.com/
|