Hello all,
Because of copious amounts of rot, I had to chop out and replace both sides
of the scuttle in the area of the mounting holes for windscreen upright
supports.
Failing to think ahead, I did not capture the exact locations of holes and
now don't know where to place windscreen. Yes Tom, I know it goes on the front
end of the car, ahead of the driver!
Would one of you kind PA owners send me measurements from front edge of
scuttle to bottom center of windscreen?
I'm also concerned about the rake angle of screen. Again, anyone have a
protractor (or alternative) to determine proper rake when screen is fully
upright?
Thanks in advance,
Don B.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|