Yes, that is an early TR2 block. TR2 blocks had no cam bearings, so they didn't
need the indexing bolts to align the oil gallery hole and key the bearing from
the chance rotating and blocking the oil passage.
I have TS2172LO a '54 longdoor TR2 with it's original engine TS2213E.
Dave H.
> On November 30, 2018 at 1:37 PM Brad Eells via Fot <fot@autox.team.net> wrote:
>
>
> Joe,
>
> What is the engine number on the block. My TR3 and 4 blocks use bolts to
> retain the cam bearings.
>
> Brad Eells
> Sent from my iPhone
>
> > On Nov 30, 2018, at 11:26 AM, Joe Alexander via Fot <fot@autox.team.net>
> > wrote:
> >
> > Kas and All.
> >
> > Sean was stripping a block and noticed that there were no Cam Bearing
> > Retainer Hardware. And the center web bridged the width of the block and
> > was machined.
> >>
> >> TS1362E
> >
> > Clearly, running design changes for a reason. Any insights on this?
> >
> > <image1.jpeg>
> >
> >
> > <image2.jpeg>
> >
> >>
> >> Joe Alexander
> >> 4505 Donald Dr
> >> Cedar Falls, IA 50613
> >> The-vintage-racer.com
> >> Gasketinnovations.com
> >> Cell: 319.464.4711
> >>
> > _______________________________________________
> > fot@autox.team.net
> >
> > http://www.fot-racing.com
> >
> > Donate: http://www.team.net/donate.html
> > Archive: http://www.team.net/pipermail/fot
> > Unsubscribe/Manage:
> > http://autox.team.net/mailman/options/fot/tr4abrad@gmail.com
> >
> >
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/fot
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/fot/dlhogye@comcast.net
>
>
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/pipermail/fot
|