| To: | sandhoff@csus.edu, foxy@pipeline.com.au |
|---|---|
| Subject: | Re: rear axle bearings and shimming |
| From: | CalSpeed@aol.com |
| Date: | Wed, 16 Aug 2000 17:13:43 EDT |
<< Now Ron can tell you how to rip a ring gear in two, and Alan can help if you have an ant infestation :-). Gordon has done rear ends and may be helpful, but again it's as much a 'laying on of hands' to get it right so maybe if you'll fund him flying over to help you out... :-) :-) >> Hey... I can help burn out a rear wheel bearing in the middle of the Artizona Desert! Michael "Calspeed" Carion |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | RE: Roll bars, Timing and Carbs (was: bolt holes), Marc Tyler |
|---|---|
| Next by Date: | Re: Roll bars, Timing and Carbs (was: bolt holes), Calvin Grandy |
| Previous by Thread: | Re: rear axle bearings and shimming, Don Miller |
| Next by Thread: | Re: rear axle bearings and shimming, datsunmike |
| Indexes: | [Date] [Thread] [Top] [All Lists] |