Re: rear axle bearings and shimming

[Gordon Glasgow <glasgow@serv.net>]

Just to clarify, I don't do ring & pinion setup. I've rebuilt a few 
limited-slip units, but I leave
r&p's to the pro's.

Wouldn't mind the vacation, but I'm afraid I wouldn't be much help.  ;-)

John F Sandhoff wrote:

> Gordon has done rear ends and may
> be helpful, but again it's as much a 'laying on of hands' to get it right
> so maybe if you'll fund him flying over to help you out... :-) :-)

--
Gordon Glasgow
http://www.gordon-glasgow.org