buick-rover-v8
[Top] [All Lists]

Re: TIMING COVER REPLACEMENT

To: "John Bartholomew" <jdb70@minerva.amdahl.com>,
Subject: Re: TIMING COVER REPLACEMENT
From: "Op" <oliverp@gte.net>
Date: Wed, 28 Apr 1999 16:24:34 -0700
Hi John,

The timing cover on the earlier Buick V6 should be the same. I beleive that
the timing marks might be different. I had the same problem as you on a 455
Pontiac I rebuilt in High School (damn, that was 20 years ago) after
grinding off the head I was able to remove the timing chain cover. Then a
few hours of soaking, and finally sharp smacks(not to hard) with a hammer
managed to break free the bolt.

Good Luck,

Op


----- Original Message -----
From: John Bartholomew <jdb70@minerva.amdahl.com>
To: <buick-rover-v8@autox.team.net>
Sent: Wednesday, April 28, 1999 1:29 PM
Subject: TIMING COVER REPLACEMENT


>Hi Gang,
>        I am slowly tearing into my Rover V8 to rebuild it for my MGB
>transplant. This is my first V8, having rebuilt many MG 4 bangers!.
>I have run up against a major snag, I am not able to remove the timing
>cover because I cannot remove one of the real long bolts as it is seized
>solid with corrosion. The head of this bolt sheared off as I was into
>removed the water pump. Now after much penetrating oil, application of heat
>and finally the MIG welder I have all but this one bolt out and it remains
>steadfast!. The water pump is now off and I have about 1/4 to 3/8 inch of
>the bolt shaft exposed. I plan on taking the whole thing into a local
>machine shop to see if he can get the thing out and preserve the timing
>cover. Failing this I feel I must resort to the destruction of the aluminum
>cover to get it off and the bolt out, so I can continue with the rebuild.
>Question for you folks out there....what are my options for a replacement
>timing cover.  Can I use one from an alternative domestic motor, if so what
>make and or model years should I look for at the local car recyclers. I bet
>there are some alternatives for this part, if only I new what they were.
>Suggestions and offers of help greatly appreciated.
>The V8 rookie, John.
>---------------------------------
>     E-mail jdb70@minerva.amdahl.com
>  John Bartholomew Amdahl San Jose CA.
>  ** 408-746-6361 07:00-16:00 PST.  **
>    **  USUAL DISCLAIMERS APPLY  **
>Various MGB & GT's (6) '69 to 79; 86 XJ-S COUPE


<Prev in Thread] Current Thread [Next in Thread>