Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*TR\-4\s+Stromberg\s+Piston\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*TR\-4\s+Stromberg\s+Piston\s*$/: 7 ]

Total 7 documents matching your query.

1. TR-4 Stromberg Piston (score: 1): Author: Unknown; Date: Mon, 14 Jan 2002 04:54:30 -0800 (PST); Howdy Folks, I was tinkering with the TR-4 again after a drive around the neighborhood. I noticed that the pistons in the Zenith Stromberg carbs don't raise equally when I open the throttle. A quick; /html/triumphs/2002-01/msg00641.html (7,260 bytes)
2. TR-4 Stromberg Piston (score: 1): Author: Unknown; Date: Mon, 14 Jan 2002 09:16:46 -0500; Message text written by Scott Tilton I noticed that the pistons in the Zenith Stromberg carbs don't raise equally when I open the throttle. A quick check with a Unisyn tool shows equal suction at idl; /html/triumphs/2002-01/msg00645.html (7,360 bytes)
3. Re: TR-4 Stromberg Piston (score: 1): Author: Unknown; Date: Mon, 14 Jan 2002 09:57:21 -0600; Oftentimes this is because of the adjustment of the two arms on the center carb linkage shaft. Notice that the throttle linkage is connected to the center shaft. Then notice that its motion is transm; /html/triumphs/2002-01/msg00650.html (8,484 bytes)
4. Re: TR-4 Stromberg Piston (score: 1): Author: Unknown; Date: Mon, 14 Jan 2002 10:17:13 -0800 (PST); I'm not sure this is right for a TR-4 with Strombergs. On mine at least. . .the linkage attaches at the front side of the front carb. The rear carb is downstream (mechanically) and is connected with; /html/triumphs/2002-01/msg00658.html (9,612 bytes)
5. RE: TR-4 Stromberg Piston (score: 1): Author: Unknown; Date: Mon, 14 Jan 2002 12:44:46 -0600 qcorp.net>; Checking the air valve diaphragm for damage takes about 2 minutes. Just remove the 4 screws from the top cover and lift it off. You'll see the black diaphragm. Check it for any cuts or tears. After; /html/triumphs/2002-01/msg00661.html (8,644 bytes)
6. Re: TR-4 Stromberg Piston (score: 1): Author: Unknown; Date: Mon, 14 Jan 2002 14:00:49 -0500; Message text written by Scott Tilton Can I take a air valve (piston) top cover from different carbs and still expect them to work together? (there are probably some issues about centering the jet or; /html/triumphs/2002-01/msg00664.html (7,824 bytes)
7. Re: TR-4 Stromberg Piston (score: 1): Author: Unknown; Date: Mon, 14 Jan 2002 16:37:06 EST; Scott, first see if the diaphragms are not torn. If they are OK, then check the springs on the piston shafts. They should be the same. Check the needles to see if they are seated properly and have no; /html/triumphs/2002-01/msg00676.html (7,757 bytes)

Current List: 1 - 7
Page: [1]