- 1. Paint code for wire wheels (score: 1)
- Author: "Dave Willner" <dwillner@ptd.net>
- Date: Wed, 26 Apr 2006 08:14:26 -0700
- Does anyone have a paint code for the factory painted 60 spoke wire wheels, circa 1970 MGB? Thanks Dave Willner Stroudsburg, PA 70 MGB 59 TR3A 70 BSA 441
- /html/mgs/2006-04/msg00242.html (6,390 bytes)
- 2. new owner questions (score: 1)
- Author: "Dave Willner" <dwillner@ptd.net>
- Date: Thu, 27 Apr 2006 08:25:48 -0700
- Just purchased a very nice 70 MGB I have a couple questions on. Both front and rear overriders seem to be tilted back slightly, doesn't seem to look correct to me, I assume they should be perfectly v
- /html/mgs/2006-04/msg00244.html (6,626 bytes)
- 3. new owner boot lid question (score: 1)
- Author: "Dave Willner" <dwillner@ptd.net>
- Date: Sat, 29 Apr 2006 08:20:05 -0700
- Is there an easy fix for a slighty raised or misaligned boot lid on the prop rod side? Apparently the lid was closed with the rod not properly stowed, a guess a very common problem....Not sure where
- /html/mgs/2006-04/msg00267.html (6,405 bytes)
- 4. switch removal questions (score: 1)
- Author: "Dave Willner" <dwillner@ptd.net>
- Date: Mon, 8 May 2006 17:21:30 -0700
- I'm replacing the yellow and faded plastic chrome trim around the switches on my 70 B and I'm having a very difficult time with the retaining springs holding the switch in from the rear. Is there a t
- /html/mgs/2006-05/msg00053.html (6,686 bytes)
- 5. replacing water pump question (score: 1)
- Author: "Dave Willner" <dwillner@ptd.net>
- Date: Sat, 13 May 2006 09:49:25 -0700
- I'm in the middle of replacing my water pump and have most everything off, the radiator, the fan, alternator, etc. I'm scratching my head trying to remove the pully. Dos this typically require an exc
- /html/mgs/2006-05/msg00101.html (6,932 bytes)
- 6. Re: Attn NJ Guys - Pending Legislation (score: 1)
- Author: "davewillner" <dwillner@ptd.net>
- Date: Mon, 6 Nov 2006 16:50:12 -0500
- That's my take too. A show a week, as well as a ride a week, sounds ok to me? Over 100 "legal" trips a year, I'm hard pressed to do half that in a year.... Dave Willner Stroudsburg, PA (former NJ guy
- /html/mgs/2006-11/msg00019.html (9,733 bytes)
- 7. '70 new top install questions (score: 1)
- Author: "davewillner" <dwillner@ptd.net>
- Date: Fri, 1 Dec 2006 14:10:19 -0500
- I just picked up a new top for my B and had a question, it's the original top I'm replacing and not sure what the protocol is for this. The rubber molding strip has the mounting bracket riveted in pl
- /html/mgs/2006-12/msg00013.html (8,247 bytes)
- 8. top install instructions (score: 1)
- Author: "davewillner" <dwillner@ptd.net>
- Date: Fri, 1 Dec 2006 15:32:57 -0500
- Does anyone have a set of instructions or a page that shows the steps to properly attach (cement) the top to the header rail, proper folds and measurements they might share? Appreciate the help, than
- /html/mgs/2006-12/msg00019.html (7,706 bytes)
- 9. top installation instructions (score: 1)
- Author: "davewillner" <dwillner@ptd.net>
- Date: Thu, 28 Dec 2006 11:19:39 -0500
- Top time....need to figure out the best way / approach to cementing to vinyl to the header rail. Does anyone have a written instruction sheet for this step they could send me or post? Its a Robbins t
- /html/mgs/2006-12/msg00210.html (6,663 bytes)
- 10. [MGS] 70 hard turning window crank and loose vent hinges (score: 1)
- Author: "davewillner" <dwillner@ptd.net>
- Date: Thu, 24 May 2007 07:26:57 -0400
- Couple questions....I'm going to replace the rubber vent seals along the bottom of the vent windows on the MGB this weekend, have some pretty good instruction, seems relatively easy. In addition I wa
- /html/mgs/2007-05/msg00125.html (7,565 bytes)
- 11. [Mgs] Luggage rack question (score: 1)
- Author: "Dave Willner" <dwillner@ptd.net>
- Date: Sat, 12 Jan 2008 17:42:05 -0500
- I purchased a NOS luggage rack from an individual, Moss item 244-710, and they didn't have the 2 long 16" chrome mounting straps with the slight arch in them. Has anyone had any luck in locating a s
- /html/mgs/2008-01/msg00085.html (6,918 bytes)
This search system is powered by
Namazu