- 141. Blast Media (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Fri, 19 May 2006 14:25:05 -0400
- I want to remove rust and paint from engine parts. What media should I use? TIA. Ned Smith BJ8 near Chattanooga, TN N34.98 W85.5
- /html/healeys/2006-05/msg00565.html (6,373 bytes)
- 142. RE: overdrive solenoid (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Sun, 21 May 2006 08:01:50 -0400
- Did you actually loosen the clamp that holds the actuating rod to the throttle switch so that the internal works can be moved independent of the rod? This situation sounds exactly like mine a month a
- /html/healeys/2006-05/msg00624.html (8,361 bytes)
- 143. RE: BJ8 window rail (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Tue, 23 May 2006 19:42:52 -0400
- Ned Smith BJ8 near Chattanooga, TN N34.98 W85.5 The bottom rail that holds the roller has come off the window frame. Should I line the rail with a thin rubber sheet and then push it back on to the w
- /html/healeys/2006-05/msg00709.html (6,839 bytes)
- 144. RE: BJ8 window rail (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Wed, 24 May 2006 07:56:53 -0400
- I used long clamps to draw the pieces together. Ned Smith BJ8 near Chattanooga, TN N34.98 W85.5 Ken and Ned, I would add that it may require some tapping with a rubber mallet or wood block and hammer
- /html/healeys/2006-05/msg00724.html (8,047 bytes)
- 145. Thermostat with Sleeve (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Thu, 25 May 2006 08:40:59 -0400
- Does anyone have a source for a 180 F, wax capsule style, with sleeve thermostat? Moss has a one for 165F but not 180F. Thanks, Ned Smith BJ8 near Chattanooga, TN N34.98 W85.5
- /html/healeys/2006-05/msg00758.html (6,318 bytes)
- 146. Radiator Question (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Thu, 25 May 2006 12:43:52 -0400
- I am cleaning up my radiator before reinstalling it in my BJ8. It took me about two hours to straighten the fins on both sides. I just noticed that a heat sensor is screwed into the bottom of the top
- /html/healeys/2006-05/msg00769.html (6,496 bytes)
- 147. RE: Sleeved Thermostats (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Thu, 25 May 2006 12:50:02 -0400
- I just looked at the Moss on-line catalog for thermostat 434-165 and it shows that it is for MGs and not available. Could you have transposed some numbers? Ned Smith BJ8 near Chattanooga, TN N34.98 W
- /html/healeys/2006-05/msg00770.html (7,957 bytes)
- 148. Tonneau Cover Bow (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Sat, 27 May 2006 16:56:57 -0400
- I just bought a used tonneau cover for my BJ8. Does anyone have a measured or full scale drawing of the bow that fits into sockets behind the front seats and supports the cover? TIA. Ned Smith BJ8 ne
- /html/healeys/2006-05/msg00813.html (6,375 bytes)
- 149. Who Rebuilds Distributors? (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Mon, 29 May 2006 12:13:48 -0400
- An archive search reveals many lines like "I should rebuild my distributor" or "I had my distributor rebuilt" but no reference I could find as to who rebuilds AH distributors. Can anyone recommend so
- /html/healeys/2006-05/msg00852.html (6,460 bytes)
- 150. Dist Rebuild (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Tue, 30 May 2006 15:15:54 -0400
- Thanks to everyone who responded to my call for help. Ned Smith BJ8 near Chattanooga, TN N34.98 W85.5
- /html/healeys/2006-05/msg00899.html (6,159 bytes)
- 151. The Biggest Leak (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Tue, 30 May 2006 15:43:52 -0400
- The biggest oil puddle under my BJ8 is not from the rear crankshaft seal but from the aft end of the OD. The drops form on the tie rod bushing and fall to the floor. I am not sure if is coming from t
- /html/healeys/2006-05/msg00901.html (6,599 bytes)
- 152. New (to me) Tonneau Cover (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Wed, 31 May 2006 08:56:40 -0400
- I recently purchased a tonneau cover for my BJ8. There are flaps with fasteners over each front seat. What are they for? TIA. Ned Smith BJ8 near Chattanooga, TN N34.98 W85.5
- /html/healeys/2006-05/msg00920.html (6,650 bytes)
- 153. OD Leaks (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Wed, 31 May 2006 16:44:32 -0400
- I drained the OD to get ready to replace the rear seal. I found three fiber (may be leather) washers on top of the strainer. I don't see them in the manuals. Could this be a mistake from previous wor
- /html/healeys/2006-05/msg00929.html (6,534 bytes)
- 154. Baulking Rings in MY BJ8 (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Sat, 3 Jun 2006 08:35:20 -0400
- I've got the top off the gear box. All the gears look pristine. No chips or rounded edges. The baulking rings look good to me but I don't know what a worn one would look like. These have three tabs t
- /html/healeys/2006-06/msg00044.html (6,644 bytes)
- 155. Overhauling Tranny (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Mon, 5 Jun 2006 17:17:27 -0400
- Further inspection, encouraged by Rich Chrysler, revealed that I need all three syncro rings. The lay shaft has some "smears" on it so I will get that too. The roller and needle bearings appear to be
- /html/healeys/2006-06/msg00093.html (6,530 bytes)
- 156. Luggage Rack (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Wed, 7 Jun 2006 18:03:24 -0400
- I just bought a luggage rack like the one Don Lenschow talked about in the "Austin Healey Magazine" for May. It doesn't have the brackets that hold the support legs to the lower trunk lip. The seller
- /html/healeys/2006-06/msg00138.html (7,374 bytes)
- 157. Gear Box Overhaul Help (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Thu, 8 Jun 2006 11:30:11 -0400
- What looked like an easy job has suddenly stalled. 1. After removing the syncro stuff for 3 and 4 gears, I hit an oddity. Both the shop manual and Moss say there should be 32 needle bearings under 3r
- /html/healeys/2006-06/msg00160.html (6,639 bytes)
- 158. What Color is Starter (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Tue, 13 Jun 2006 07:59:13 -0400
- I am spiffing up auxiliary units getting ready to reassemble the engine. Should the starter be painted engine color? Ned Smith BJ8 near Chattanooga, TN N34.98 W85.5
- /html/healeys/2006-06/msg00179.html (6,479 bytes)
- 159. Carburetor Darin Pipe Clips (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Mon, 12 Jun 2006 15:48:08 -0400
- Looking through the nuts and bolts that fasten the oil pan to the block, I find I don't have the two clips and ferrules that hold the drain pipes to the oil pan. Both Moss and Victoria British doesn'
- /html/healeys/2006-06/msg00202.html (6,858 bytes)
- 160. Fuel Drains (score: 1)
- Author: "Ned Smith" <smithn00@kitepilot.net>
- Date: Tue, 13 Jun 2006 17:36:05 -0400
- Thanks to everyone for fuel drain clip suggestions. Ned Smith BJ8 near Chattanooga, TN N34.98 W85.5
- /html/healeys/2006-06/msg00247.html (6,165 bytes)
This search system is powered by
Namazu