<< Today in San Francisco the weather was once again perfect for a top down cruise. I popped in the baby seat on the passenger side and Rose and I went for our cruise through Golden Gate Park and the
If you want to build just a shed with a slab on grade floor that's one thing. If you plan on enclosing it that's a different story. Up in BC you will need full footings if you plan on enclosing it or
<< The Nerve of those guys! We don't use MG parts to rebuild our Roadsters! We don't use MG parts to rebuild our lawn mowers never mind our roadsters. DAVE
Hey List. Anyone have first hand experience with putting a 1600 rear end differential on a 2000. I know on paper it should be faster off the line but is it noticeable in the actual car. Also there is
If its the rubber seal on the vent under the dash go to a commercial roofing supplier. They will probably just give you a piece of their thickest rubber roof membrane. Cut 2 pieces to fit and contact
Hey list, Any suggestions on replacing the 6'' hose on the 68-70 heater control without buying the whole unit with valve. The bend is too sharp to do with off the roll hose. Its my understanding the
<< Hi Everyone, I'll be buying a 68 2000 within the next month, and the carbs have been completely re-worked by Ztherapy. It has been sitting for quite a while, so I wanted to take out the gas tank,
I have also heard that the task was monumental. To be honest I had no trouble at all putting my new soft top on. It came out great. I also only spent $150 on the top from a soft top place in Chelsea
Hey Folks. Once again one of my after market ignition wires is acting up. What is the absolute best set of wires I can get for the roadster? Also there has been a lot of talk about Petronix ignition.
<< I would like to know the proper pressure settings for a oxy/ acetylene cutting torch. It has been at least ten years since I have used one and can't recall the settings. It varies as to tip size.
<< And my question: What is a good way to get that windshield in without breaking it? My plan is this: 1) put gaskes on windshield, not in metal channels. 2) lube up gaskets with glycerin 3) insert w
<< I recently discovered that I do not have a set of OEM knobs on my dash and console (those wretches at the Datsun dealer sold me the wrong parts back in 75!). I am in process of replacing them. Wha
<< http://www.nidlink.com/~bitterrootprop/joe5.jpg >> Its either an spl 212 around 1961 or a later 213 around 1962 Do I win the car for guessing right ????? Dave M
Hey List. Anyone have a suggestion as to a hotel that might still have a room for the Sept 8-10 weekend. OR, does anyone have a spare reservation that they don't need that I could transfer to my cred
<< I own a couple of SRL-311's and enjoy them even though they don't run. I have a concern though because on my '69 car the hand throttle sleeve & cable are cut back behind the firewall well inside t
<< It was written, concerning fuel pumps: Yes, that belongs there. I imagine leaving it off will shift the wear spot on the pump arm, probably won't pump right and could possibly hurt the jackshaft a