Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*regular\s+or\s+hardened\s+lifters\s+for\s+stock\s+cam\?\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*regular\s+or\s+hardened\s+lifters\s+for\s+stock\s+cam\?\s*$/: 6 ]

Total 6 documents matching your query.

1. regular or hardened lifters for stock cam? (score: 1): Author: Jay Snable <jsnable@mac.com>; Date: Sun, 24 Aug 2003 11:56:05 -0700; I am thinking about putting my old stock cam (doing some experimenting). This cam has about 15k miles on it, and unfortunately I think that the matching lifters are lost. Looking at BPNW I see both r; /html/6pack/2003-08/msg00488.html (7,468 bytes)
2. Re: regular or hardened lifters for stock cam? (score: 1): Author: "Bob Fabie" <RFabie@erols.com>; Date: Sun, 24 Aug 2003 15:31:51 -0400; I'd recommend the hardened lifters from BPNW. I just installed a new stock TR6 cam. Are your lifters bad? What happened? Bob Fabie /// 6pack@autox.team.net mailing list /// or try http://www.team.net; /html/6pack/2003-08/msg00489.html (7,436 bytes)
3. Re: regular or hardened lifters for stock cam? (score: 1): Author: Jay Snable <jsnable@mac.com>; Date: Sun, 24 Aug 2003 15:09:29 -0700; Here is the whole story... I bought a Kent cam kit (cam, lifters and springs) a few years ago during a TRF sale. I haven't been that happy with it, mainly due to lumpy idle even at about 1200rpm. It; /html/6pack/2003-08/msg00491.html (8,897 bytes)
4. Re: regular or hardened lifters for stock cam? (score: 1): Author: tr6taylor@webtv.net (Sally or Dick Taylor); Date: Sun, 24 Aug 2003 22:59:55 -0700 (PDT); Jay--The Strombergs and the original cam grind should give a smooth idle, if this is what you are asking. The higher CR shouldn't upset this. The vacuum signal should be between 18 and 22 inches, dep; /html/6pack/2003-08/msg00495.html (8,123 bytes)
5. RE: regular or hardened lifters for stock cam? (score: 1): Author: "Navarrette, Vance" <vance.navarrette@intel.com>; Date: Mon, 25 Aug 2003 07:55:50 -0700; If the original lifters are gone, or you cannot remember which lifter goes with which lobe, the old cam is only good for a regrind core. You will not be able to reinstall it and have it survive more; /html/6pack/2003-08/msg00501.html (8,481 bytes)
6. Re: regular or hardened lifters for stock cam? (score: 1): Author: Jay Snable <jsnable@mac.com>; Date: Tue, 26 Aug 2003 20:21:30 -0700; I just wanted to update the list on the off-line replies I received regarding my potential cam swap. First, Vance recommended that I not just put the cam back in with new lifters, but have it regroun; /html/6pack/2003-08/msg00541.html (8,122 bytes)

Current List: 1 - 6
Page: [1]