HI Roger,
Good luck with the Cruise control.
Out of curiosity, what are some of the destinations you are looking at? I
would like to do some long trips this summer in my TR4A, especially since I
am retiring this April. Already have plans to drive from Cincinnati to
Watkins Glen in September but summer is over by then.
How about the rest of you guys?
Dave Connitt
'67 TR4A IRS
http://DavesTR4A.com
-----Original Message-----
From: Triumphs <triumphs-bounces@autox.team.net> On Behalf Of Roger Elliott
Sent: Wednesday, January 30, 2019 3:29 PM
To: triumphs@autox.team.net
Subject: [TR] TR 250 (TR4) Cruise control
Hi,
We are planning some long excursions this year in the TR 250, so I would
like to install a cruise control in the TR 250.
There have been two basic options mentioned in various posts.
1) The Rostra unit which is more expensive and seems to require have more
installation requirements (for example a sensor on the drive shaft to
register speed.)
http://www.rostra.com/universal-aftermarket-cruise-control-by-rostra.php
2) The recreation of the Audiovox cruise control, which requires a vacuum
canister. Quite a bit cheaper than the Rostra.
https://www.murphskits.com/product_info.php?cPath=25&products_id=422&osCsid=
PYoe2OY2I0duN1IkGnMJ1
I have seen articles for installing both, but on carbs with a cable linkage
but none with the throttle linkage like the early TRs.
Has anyone installed on or the other on a TR250, TR4, etc that has the rods,
levers, bell crank arrangement? If so, how did you make the connection?
Thanks,
Roger Elliott
** triumphs@autox.team.net **
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
http://autox.team.net/mailman/options/triumphs/dconnitt@fuse.net
** triumphs@autox.team.net **
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
|