--===============1674586076648414347==
--000000000000abd8fc057ff23972
The PO put gallons of sealer around the pan/ sump and over tightened all
the bolts. They are all raises and .if I put a flat rule between holes, I
can notice at least 1 or more mm gap.
I am thinking of using a nut and bolt with a few washers to hopefully make
the bolts holes flat again. Are there any other good simpler ways to do
this. I don't want to hammer them as I think I will do more damage.
Sujit
--
Sujit Roy
Cupertino, California
https://triumphstagblog.wordpress.com/
--000000000000abd8fc057ff23972
Content-Transfer-Encoding: quoted-printable
<div dir=3D"ltr">=C2=A0 The PO put gallons of sealer around the pan/ sump a=
nd over tightened all the bolts. They are all raises and .if=C2=A0 I put a =
flat rule between holes, I=C2=A0 can notice at least 1 or more mm gap.<br><=
br>I am thinking of using a nut and bolt with a few washers to hopefully ma=
ke the bolts holes flat again. Are there any other good simpler ways to do =
this. I don't want to hammer them as I think I will do more damage.<br>=
<br>Sujit=C2=A0=C2=A0<br clear=3D"all"><div><br></div>-- <br><div dir=3D"lt=
r" class=3D"gmail_signature" data-smartmail=3D"gmail_signature"><div dir=3D=
"ltr"><div>Sujit Roy<br>Cupertino, California</div><div><br><a href=3D"http=
s://triumphstagblog.wordpress.com/" target=3D"_blank">https://triumphstagbl=
og.wordpress.com/</a><br><br></div></div></div></div>
--000000000000abd8fc057ff23972--
--===============1674586076648414347==
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
** triumphs@autox.team.net **
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
--===============1674586076648414347==--
|