Many thanks to those that responded. Jim henningsen
From: John Macartney [mailto:flywheelcoventry1@yahoo.co.uk]
Sent: Friday, November 15, 2013 11:58 AM
To: James Henningsen; triumphs@autox.team.net
Subject: Re: [TR] Head Question
Factory used a normal lightweight general purpose grease lightly smeared
with a finger on the block face, both sides of the gasket and the underside
of the head.
Jonmac
From: James Henningsen <trguy75@gmail.com>
To: triumphs@autox.team.net
Sent: Friday, 15 November 2013, 15:14
Subject: [TR] Head Question
Ok, this is probably a dumb question, but better safe than sorry. Do you
use any gasket sealant when installing a new copper head gasket on a TR4
motor?
Thanks,
Jim Henningsen
Ocala FL
62 TR4
75 TR6
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
http://autox.team.net/mailman/options/triumphs/flywheelcoventry1@yahoo.co.uk
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|