Roger,
Cracked floats would do it! The floats get saturated with fuel and don't
"float" anymore! I would suspect your fuel pump pressure but you said it
ran fine with that fuel pump until now. I assume you're using a fuel filter
so we can rule out nasty bits of dirt clogging the valves....if the float
level is set to spec and the pump hasn't suddenly decided to put out 8 or
10psi, I'm guessing that there's a crack in one of your floats.
Chip Krout
Delaware Valley Triumphs, Ltd.
Skippack, PA
1976 TR6 CF57822U
In a message dated 5/10/2012 12:07:24 P.M. Eastern Daylight Time,
elliottr at rmi.net writes:
Assuming I haven't botched installing the needle valves and floats, is
there anything besides excess fuel pressure that would cause the bowls to
overflow?
|