George,
If your commission number is under TS50000 you need the ribbed letter,
smooth letters if over. You may have done this but my PO had just filled
the holes with bondo, I re-located them by sanding on the backside then
drilling them out.
Bill
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of George
Sent: Saturday, August 06, 2011 7:35 PM
To: triumphs@autox.team.net
Subject: [TR] tr3A Front Apron
My TR3a front apron does not have the chrome letters on the front. I think
it could be an aftermarket part since there are no holes drilled for the
letters to be attached. Does anyone know how anyone could drill the holes
to be able to put the Triumph letters where they are supposed to be? Is
there a pattern or something anyone could use to lay out the pattern? Or
should I just leave it as is? I have seen one at a car show that did not
have the letters and didn't look too bad. Any ideas? George M. 60 TR3a
Waleska GA
_______________________________________
No infections found in this outgoing message Scanned by iolo System Shield.
http://www.iolo.com
triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/wbeech@flash.net
triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|