My TR3a front apron does not have the chrome letters on the front. I think
it could be an aftermarket part since there are no holes drilled for the
letters to be attached. Does anyone know how anyone could drill the holes
to be able to put the Triumph letters where they are supposed to be? Is
there a pattern or something anyone could use to lay out the pattern? Or
should I just leave it as is? I have seen one at a car show that did not
have the letters and didn't look too bad. Any ideas? George M. 60 TR3a
Waleska GA
_______________________________________
No infections found in this outgoing message
Scanned by iolo System Shield.
http://www.iolo.com
|