The reamer will still be turned in the same direction. The difference is
that you will want it to cut from the shank end of the flutes instead of
from the normal end. To do this, the back end of the flutes must have a
shape with a cutting angle put on them. The shank will pass through both
bushing holes to keep them aligned.
Greg Gelhar
----- Original Message -----
From: "Gary Nafziger" <nafzigerg@yahoo.com>
To: <triumphs@autox.team.net>
Sent: Wednesday, March 16, 2011 9:05 PM
Subject: [TR] modifying a reamer for carb shaft
> Randall sent a link to a good article concerning reaming your own carb for
> new
> bushings for throttle shafts.
>
> One suggestion included grinding the cutting edges of the flutes on the
> reamer
> to make them work in reverse. I'm not familiar enough with reamers. How
> simple
> is this? I'm guessing that it involves grinding one side of the cutting
> edge to
> make a "burr" on the other side of the cutting edge?
>
>
> Is the cutting edge of a reamer sharp and angled one direction (which
> needs to
> be changed the other direction by grinding?)
> Or is the cutting edge of a reamer square with a little angle?
> It looks doable to me and hopefully I can start soon.
>
> gary n.
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|