Randall sent a link to a good article concerning reaming your own carb for new
bushings for throttle shafts.
One suggestion included grinding the cutting edges of the flutes on the reamer
to make them work in reverse. I'm not familiar enough with reamers. How
simple
is this? I'm guessing that it involves grinding one side of the cutting edge
to
make a "burr" on the other side of the cutting edge?
Is the cutting edge of a reamer sharp and angled one direction (which needs to
be changed the other direction by grinding?)
Or is the cutting edge of a reamer square with a little angle?
It looks doable to me and hopefully I can start soon.
gary n.
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|