I used hemostats like Dr's use and no problem with my 72 TR6 doors.
Craig
Jan 17, 2011 01:52:48 PM, rpeglow at optonline.net wrote:
Hello Darrell,
I used a cut down piece of a finishing nail that is a tiny bit narrower than
that barrel instead.
It went in easy and spring pressure keeps a hold on it, been working just
fine.
You might give it a try.
Regards,
Bob
-----Original Message-----
From: 6pack-bounces at autox.team.net [mailto:6pack-bounces at autox.team.net]
On
Behalf Of TR250Driver at aol.com
Sent: Monday, January 17, 2011 1:26 PM
To: triumphs at autox.team.net
Cc: 6pack at autox.team.net
Subject: [6pack] TR6 Inside Door Handle Installation
Hey Guys,
I have about an hour in it now with Beverly helping. No success, we just
gave up. Trying to get that little barrel into both holes with the springs
behind the door is impossible!!!!! I have done this before but I think I
always coped out and took the springs out. Then it is just very difficult.
I have the door glass replaced, the panel back on and all I need is the
handles back on.
I hear there is a special tool for this. Anyone know where I can buy one?
Any tips on how to make this job possible? I tried using needle nose vise
grips & needle nose pliers.
Thanks,
Darrell
_______________________________________________
6pack at autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/6pack/rpeglow at optonline.net
_______________________________________________
Triumphs at autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Manage your account: http://autox.team.net/mailman/options/triumphs/thenicholls
at verizon.net
|