I use a straight pick and tape the barrel to it with masking tape or
electrical tape.
I use 1 or two flat blade screw drivers to hold the plastic piece down and
put the barrel in place with the pick.
Al
----- Original Message -----
From: <TR250Driver@aol.com>
To: <triumphs@autox.team.net>
Cc: <6pack@autox.team.net>
Sent: Monday, January 17, 2011 1:26 PM
Subject: [6pack] TR6 Inside Door Handle Installation
> Hey Guys,
> I have about an hour in it now with Beverly helping. No success, we just
> gave up. Trying to get that little barrel into both holes with the
> springs
> behind the door is impossible!!!!! I have done this before but I think I
> always coped out and took the springs out. Then it is just very
> difficult.
> I have the door glass replaced, the panel back on and all I need is the
> handles back on.
>
> I hear there is a special tool for this. Anyone know where I can buy
> one?
> Any tips on how to make this job possible? I tried using needle nose
> vise grips & needle nose pliers.
>
> Thanks,
> Darrell
> _______________________________________________
>
> 6pack@autox.team.net
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/6pack/tr6parts@charter.net
>
>
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|