Bob, thanks!
Do you know what type fittings it has?
I have a different mc than the original (it's County brand), but, I lost
the adapters it uses for this particular mc line.
Thanks, Paul
----- Original Message -----
From: "Bob" <rpeglow@optonline.net>
To: <triumphs@autox.team.net>
Sent: Tuesday, May 05, 2009 9:42 PM
Subject: [TR] thickness of clutch mc to slave line?
>I recently used the stock pipe piece from TRF PN 148816.
> It required minimal reshaping and worked just fine.
> Regards,
> Bob
>
>
> >
>> On May 5, 2009, at 5:44 AM, dorpaul wrote:
>>
>> > Hi,
>> >
>> > Is it correct to use the same size tubing
>> > between the Clutch MC and it's slave cylinder
>> > as that of the brake line (I think that's 1/8" tubing, right?).
>> > Is there any benefit to using a larger diameter tubing for this
>> > line? If so,
>> > I'll need to obtain fittings for the larger tube (from where?).
>> >
>> > Thanks, Paul Dorsey
>> > _____
>>
>
>
>
>
> E-mail message checked by Spyware Doctor (6.0.0.386)
> Database version: 5.12320
> http://www.pctools.com/en/spyware-doctor-antivirus/
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
>
> Triumphs@autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
> You are subscribed as dorpaul@bellsouth.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|