I recently used the stock pipe piece from TRF PN 148816.
It required minimal reshaping and worked just fine.
Regards,
Bob
>
> On May 5, 2009, at 5:44 AM, dorpaul wrote:
>
> > Hi,
> >
> > Is it correct to use the same size tubing
> > between the Clutch MC and it's slave cylinder
> > as that of the brake line (I think that's 1/8" tubing, right?).
> > Is there any benefit to using a larger diameter tubing for this
> > line? If so,
> > I'll need to obtain fittings for the larger tube (from where?).
> >
> > Thanks, Paul Dorsey
> > _____
>
E-mail message checked by Spyware Doctor (6.0.0.386)
Database version: 5.12320
http://www.pctools.com/en/spyware-doctor-antivirus/
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|