> Are you saying that the vane is not through bored and
> that the shaft does not reach through the vane to have the
> same end float clearance as the vane against the lower
> plate?
Dunno nuttin about TR6 pumps, but that sounds a lot like some bad TR2-4
pumps that were on the market a few years back. Instead of being properly
pinned, the shaft was knurled and pressed into the vanes. They had a nasty
habit of working loose.
Randall
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|