Gary,
I have installed a replacement pump in a rebuild that has had initial start
but has no run time. I do not recall the new pump. Are you saying that the
vane is not through bored and that the shaft does not reach through the vane
to have the same end float clearance as the vane against the lower plate? It
sounds like what you are saying is that the shaft is not pinned AND has the
ability to end float into a hole with bottom clearance.
Who did you buy this from and where are the product techs reviewing this
stuff?
David Lylis
69 TR6 CC26160L
60 TR3A TS74461LO
**************Psssst...Have you heard the news? There's a new fashion blog,
plus the latest fall trends and hair styles at StyleList.com.
(http://www.stylelist.com/trends?ncid=aolsty00050000000014)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|