Any Stag differential rebuilders out there ?
Looking for suggestions on what to use in place of Churchill S316, the
special tool to grab the splines on the pinion shaft while tightening the
nut.
I could make one on the lathe, but would have to cut all those dang splines
by hand. Hoping there's an easier way.
Randall
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|