Did you ever get a reply on this?
I will be rebuilding my Spitfire Diff. soon, so I would like to follow your
progress on this...
Thanks, Eric, Austin Tx.
----- Original Message -----
From: "Randall" <tr3driver@ca.rr.com>
To: "Triumph Stag Discussion Forum" <stag@digest.net>; "Triumphs"
<triumphs@autox.team.net>
Sent: Sunday, May 18, 2008 2:24 PM
Subject: [TR] Stag diff rebuilt
> Any Stag differential rebuilders out there ?
>
> Looking for suggestions on what to use in place of Churchill S316, the
> special tool to grab the splines on the pinion shaft while tightening the
> nut.
>
> I could make one on the lathe, but would have to cut all those dang
> splines
> by hand. Hoping there's an easier way.
>
> Randall
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
>
> Triumphs@autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
> You are subscribed as ebutschek@austin.rr.com
>
> http://www.team.net/archive
>
>
> No virus found in this incoming message
> Checked by PC Tools AntiVirus (4.0.0.26 - 10.072.008).
> http://www.pctools.com/free-antivirus/
No virus found in this outgoing message
Checked by PC Tools AntiVirus (4.0.0.26 - 10.072.023).
http://www.pctools.com/free-antivirus/
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|